Differences

This shows you the differences between two versions of the page.

--- reprap:anet:a8:layer-heights [2017/01/11 23:26] – old revision restored (2016/12/28 12:15) nerolauda
+++ reprap:anet:a8:layer-heights [2017/01/11 23:35] – nerolauda
@@ Line 1: / Line 1: @@
 ====== Valid Layer Heights ======
-Based on the pitch 1.25mm of the Anet A8 Z-Axis threaded rods M8, the Z-Motor 200 steps per revolution , and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of valid layer heights: ** 0.0125, ..., 0.025,..., 0.5, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts.
+Based on the pitch 1.25mm of the Anet A8 Z-Axis threaded rods M8, the Z-Motor 200 steps per revolution , and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of valid layer heights: ** 0.0125, ..., 0.025,..., 0.05, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts.
 PLS DO NOT RESTORE WRONG VALUES