reprap:anet:a8:improvements:thumbwheelleveling

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revisionBoth sides next revision
reprap:anet:a8:improvements:thumbwheelleveling [2017/01/26 15:40] – [Why] hangnailreprap:anet:a8:improvements:thumbwheelleveling [2017/10/25 09:25] – [Howto] vidschofelix
Line 20: Line 20:
   * remove the hotbed from the carrier (remove the wingnuts and take it off)   * remove the hotbed from the carrier (remove the wingnuts and take it off)
   * drill out the holes at the carrier   * drill out the holes at the carrier
-  * insert the m3 screws the were on the heated bed before again, but dont apply the springs+  * insert the m3 screws that were on the heated bed before again, but dont apply the springs
   * apply one m3 nut on each screw, tigthen it against the heated bed   * apply one m3 nut on each screw, tigthen it against the heated bed
   * now apply the thumbwheels   * now apply the thumbwheels
  • reprap/anet/a8/improvements/thumbwheelleveling.txt
  • Last modified: 2018/12/02 02:27
  • by 127.0.0.1