Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
reprap:anet:a8:improvement:autobedleveling [2019/04/01 09:10]
0scar [Are your X and Y offsets correct?]
reprap:anet:a8:improvement:autobedleveling [2019/04/30 09:44] (current)
0scar [Is your Z-offset correct?]
Line 269: Line 269:
   - Reset the existing Z-offset to zero <​code>​M851 Z0</​code>​   - Reset the existing Z-offset to zero <​code>​M851 Z0</​code>​
   - Home all axes <​code>​G28</​code>​   - Home all axes <​code>​G28</​code>​
-  - Move the nozzle to the middle<​code>​G1 X110 Y110</​code>​+  - Move the nozzle to the middle ​of the bed <​code>​G1 X110 Y110</​code> ​(if your bed is 220 x 220)
   - Turn off the software endstops with <​code>​M211 S0</​code>​   - Turn off the software endstops with <​code>​M211 S0</​code>​
   - Move the nozzle down so it is just gripping a piece of standard printer paper   - Move the nozzle down so it is just gripping a piece of standard printer paper
   - Set the Z-offset to the displayed value. E.g. if the printer displays a Z-Value of -1.23 enter <​code>​M851 Z-1.23</​code>​   - Set the Z-offset to the displayed value. E.g. if the printer displays a Z-Value of -1.23 enter <​code>​M851 Z-1.23</​code>​
-  - Store it to the EEPROM<​code>​M500</​code>​ +  - Store it to the EEPROM <​code>​M500</​code>​ 
-  - **Important** Enable the endstops again with <​code>​M211 S1</​code>​ or the printer head will collide with the bed on the next G28 command+  - **Important ​notice!** Enable the endstops again with <​code>​M211 S1</​code>​ or the printer head will collide with the bed on the next <​code>​G28</​code> ​command
  
  
  • reprap/anet/a8/improvement/autobedleveling.txt
  • Last modified: 2019/04/30 09:44
  • by 0scar