Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:anet:a8:improvement:autobedleveling [2021/05/09 08:32] – external edit 127.0.0.1 | reprap:anet:a8:improvement:autobedleveling [2023/11/02 00:35] (current) – fdll | ||
---|---|---|---|
Line 169: | Line 169: | ||
For the following G-code "M48 P50 X100 Y100 V4" was used to obtain the values for the table above. | For the following G-code "M48 P50 X100 Y100 V4" was used to obtain the values for the table above. | ||
==== Measuring your heat bed flatness ==== | ==== Measuring your heat bed flatness ==== | ||
+ | |||
+ | If you have Octoprint installed on your 3D printer use built in operation: | ||
+ | https:// | ||
+ | |||
+ | Without Octoprint but you will be limited 7X7 Matrix: | ||
+ | |||
With the "G29 T P10 V4" your printer will scan your heatbed in a 10x10 point matrix. | With the "G29 T P10 V4" your printer will scan your heatbed in a 10x10 point matrix. | ||
Line 177: | Line 183: | ||
Only works with at least a 7x7 Matrix! If you use a smaller matrix, use the link below | Only works with at least a 7x7 Matrix! If you use a smaller matrix, use the link below | ||
- | Another, more interactive online tool can be found [[http:// | + | <del>Another, more interactive online tool can be found [[http:// |
{{ : | {{ : |