Differences

This shows you the differences between two versions of the page.

--- reprap:anet:a8:improvement:autobedleveling [2021/05/09 08:32] – external edit 127.0.0.1
+++ reprap:anet:a8:improvement:autobedleveling [2023/11/02 00:32] – fdll
@@ Line 169: / Line 169: @@
 For the following G-code "M48 P50 X100 Y100 V4" was used to obtain the values for the table above.
 ==== Measuring your heat bed flatness ====
+If you have Octoprint installed on your 3D printer use built in operation:
+https://3dprintscape.com/octoprint-bed-level-visualizer-complete-setup-guide/
+Without Octoprint but you will be limited 7X7 Matrix:
 With the "G29 T P10 V4" your printer will scan your heatbed in a 10x10 point matrix.
@@ Line 177: / Line 182: @@
 Only works with at least a 7x7 Matrix! If you use a smaller matrix, use the link below
-Another, more interactive online tool can be found [[http://lokspace.eu/3d-printer-auto-bed-leveling-mesh-visualizer/|here]] - paste the same output as above.
+<del>Another, more interactive online tool can be found [[http://lokspace.eu/3d-printer-auto-bed-leveling-mesh-visualizer/|here]] - paste the same output as above</del>. Web page No longer available
 {{ :reprap:anet:a8:improvement:lokspace-g29-visualizer.jpg?400 |}}