reprap:anet:a8:improvement:autobedleveling

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
reprap:anet:a8:improvement:autobedleveling [2019/04/30 11:44] – [Is your Z-offset correct?] 0scarreprap:anet:a8:improvement:autobedleveling [2021/01/20 02:50] – Updated Soft Endstop info zylean
Line 66: Line 66:
   - Autohome your printer   - Autohome your printer
   - place a sheet of paper beneath the nozzle (make sure it is clean)   - place a sheet of paper beneath the nozzle (make sure it is clean)
 +  - Go into Prepare -> Move Axis and disable Soft Endstops
   - move Z-axis down by steps of 0.1 until it touches the paper.   - move Z-axis down by steps of 0.1 until it touches the paper.
   - note the Z value (i.e 0.7mm) and subtract it from the initial value (2mm-0.7mm).   - note the Z value (i.e 0.7mm) and subtract it from the initial value (2mm-0.7mm).
Line 145: Line 146:
 In the case that the sensor is outside of the plate after homing the Y and X axis, use Z safe homing (applies if you are using a sensor support with a negative Y-offset: In the case that the sensor is outside of the plate after homing the Y and X axis, use Z safe homing (applies if you are using a sensor support with a negative Y-offset:
     #define Z_SAFE_HOMING     #define Z_SAFE_HOMING
 +    
 +Enable the Soft Endstops option in the menu by uncommenting:
 +    #define SOFT_ENDSTOPS_MENU_ITEM
  
 ===== Slicer settings ===== ===== Slicer settings =====
  • reprap/anet/a8/improvement/autobedleveling.txt
  • Last modified: 2023/11/02 00:35
  • by fdll