Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
reprap:anet:a8:improvement:autobedleveling [2019/04/01 11:10] – [Are your X and Y offsets correct?] 0scar | reprap:anet:a8:improvement:autobedleveling [2019/04/30 11:44] – [Is your Z-offset correct?] 0scar | ||
---|---|---|---|
Line 269: | Line 269: | ||
- Reset the existing Z-offset to zero < | - Reset the existing Z-offset to zero < | ||
- Home all axes < | - Home all axes < | ||
- | - Move the nozzle to the middle< | + | - Move the nozzle to the middle |
- Turn off the software endstops with < | - Turn off the software endstops with < | ||
- Move the nozzle down so it is just gripping a piece of standard printer paper | - Move the nozzle down so it is just gripping a piece of standard printer paper | ||
- Set the Z-offset to the displayed value. E.g. if the printer displays a Z-Value of -1.23 enter < | - Set the Z-offset to the displayed value. E.g. if the printer displays a Z-Value of -1.23 enter < | ||
- | - Store it to the EEPROM< | + | - Store it to the EEPROM < |
- | - **Important** Enable the endstops again with < | + | - **Important |