Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
reprap:anet:a8:improvement:autobedleveling [2019/03/24 13:06] – pauliunas | reprap:anet:a8:improvement:autobedleveling [2019/04/01 11:10] – [Are your X and Y offsets correct?] 0scar | ||
---|---|---|---|
Line 243: | Line 243: | ||
For ABL to work correctly it is **essential** that the printer knows the exact offset from the nozzle to the probe, otherwise any correction is not going to be applied in the right place, and it may look like the printer isn't correcting at all. | For ABL to work correctly it is **essential** that the printer knows the exact offset from the nozzle to the probe, otherwise any correction is not going to be applied in the right place, and it may look like the printer isn't correcting at all. | ||
- | If you downloaded SkyNet3D and used one of the example configurations, | + | If you downloaded SkyNet3D |
These are the relevant lines: | These are the relevant lines: |