Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| reprap:anet:a8:improvement:autobedleveling [2018/12/29 00:33] – Typo fix 0scar | reprap:anet:a8:improvement:autobedleveling [2019/03/24 13:06] – pauliunas | ||
|---|---|---|---|
| Line 152: | Line 152: | ||
| ==== Gcode (only needed if there is no configuration file available for download) ==== | ==== Gcode (only needed if there is no configuration file available for download) ==== | ||
| === Auto home === | === Auto home === | ||
| - | Before homing of the Z axis the probe has to be positioned above the heat bed. When the code G28 is send to the printer this is done automatically. But if "G28 Z" is send it is not. This is the case for some Cura 2.1 json files. | + | Before homing of the Z axis the probe has to be positioned above the heat bed. When the code G28 is sent to the printer this is done automatically. But if "G28 Z" is sent it is not. This is the case for some Cura 2.1 json files. |
| === Auto level === | === Auto level === | ||
| The G code G29 starts the autolevel procedure. It should be executed after the G28 command | The G code G29 starts the autolevel procedure. It should be executed after the G28 command | ||