Differences

This shows you the differences between two versions of the page.

--- reprap:anet:a8:coupler [2019/01/03 08:12] – [Apply your coupler] cj_elec_tech
+++ reprap:anet:a8:coupler [2019/01/03 08:16] (current) – [But my axis still wobbles!] cj_elec_tech
@@ Line 21: / Line 21: @@
 ===== But my axis still wobbles! =====
-There are many reasons for unwanted movements. Take a look at the [[reprap:anet:a8#troubleshooting|troubleshooting]], print some [[reprap:anet:a8#frame_stabilization|frame stabilizations]] and tighten your belts. Be aware of all these so-called anti z-wobble devices found; especially those that constrain the threaded rod at the top of the printer. Fixating the top of the rod makes the rods statically indeterminate, basically meaning that you over constrain the system. This will not help reduce z-wobble. True anti z-wobble devices decouple x and y movement from z movement and/or take the spring movement out of the coupler by constraining the threaded rod at the bottom, but above the coupler.
+There are many reasons for unwanted movements.
+Take a look at the [[reprap:anet:a8#troubleshooting|troubleshooting]], print some [[reprap:anet:a8#frame_stabilization|frame stabilizations]] and tighten your belts.
+Be aware of all the so-called anti z-wobble devices found - especially those that constrain the threaded rod at the top of the printer. Securing the top of the rod makes the rod statically indeterminate, basically meaning that you over constrain the system. This will not help reduce z-wobble.
+True anti z-wobble devices decouple x and y movement from z movement and/or take the spring movement out of the coupler by constraining the threaded rod at the bottom, above the coupler.