Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:anet:a8:coupler [2019/01/03 08:09] – [The correct installation] cj_elec_tech | reprap:anet:a8:coupler [2019/01/03 08:16] (current) – [But my axis still wobbles!] cj_elec_tech | ||
---|---|---|---|
Line 13: | Line 13: | ||
The green marks show how deep the rods should sit in the coupler. The red mark shows where they should not go. ;) | The green marks show how deep the rods should sit in the coupler. The red mark shows where they should not go. ;) | ||
- | ===== Apply your coupler ===== | + | ===== Tighten |
- | Remember to tighten the screws on the coupler | + | Remember to tighten the screws on the coupler |
^ ^ ^^^^ | ^ ^ ^^^^ | ||
- | |1 (first screw)|3(third screw)| | + | |1 (first screw)|3 (third screw)| |
- | |4(last screw)|2(second screw)| | + | |4 (last screw)|2 (second screw)| |
===== But my axis still wobbles! ===== | ===== But my axis still wobbles! ===== | ||
- | There are many reasons for unwanted movements. Take a look at the [[reprap: | + | There are many reasons for unwanted movements. |
+ | Take a look at the [[reprap: | ||
+ | |||
+ | Be aware of all the so-called anti z-wobble devices found - especially those that constrain the threaded rod at the top of the printer. | ||
+ | |||
+ | True anti z-wobble devices decouple x and y movement from z movement and/or take the spring movement out of the coupler by constraining the threaded rod at the bottom, above the coupler. |