Differences

This shows you the differences between two versions of the page.

--- reprap:anet:a8:coupler [2019/01/03 08:06] – [Howto install the z-couplers (the right way)] cj_elec_tech
+++ reprap:anet:a8:coupler [2019/01/03 08:09] – [The correct installation] cj_elec_tech
@@ Line 5: / Line 5: @@
 ===== The correct installation =====
-It's simple: The middle of the coupler must be flexible. So don't insert the rods until they touch each other, just insert the rods on both sides for **5mm**. They have to get in touch with the screws, but they dont need go in all the way.
+It's simple: The middle of the coupler must be flexible. So don't insert the rods until they touch each other, just insert the rods on both sides **5mm**. They have to go just past the screws, but they don't need go in all the way.
 A simple illustration:
@@ Line 11: / Line 11: @@
 {{:reprap:anet:a8:dsc03281.jpg?400|Applied z-coupler with marks for right insertion}}
-The green marks show how deep the rods should sit in the coupler. The red mark shows where they shall not pass. ;)
+The green marks show how deep the rods should sit in the coupler. The red mark shows where they should not go. ;)
 ===== Apply your coupler =====