This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision |
reprap:anet:a6 [2016/11/15 08:01] – [Troubleshooting] bruce_bann0r | reprap:anet:a6 [2018/12/02 02:27] (current) – external edit 127.0.0.1 |
---|
===== General Info ===== | ===== General Info ===== |
source [[http://www.anet3d.com/English/3D_Printer/105.html|anet3d.com]] | source [[http://www.anet3d.com/English/3D_Printer/105.html|anet3d.com]] |
| * [[https://pevly.com/anet-a8-vs-a6/|comparision to A8]] |
==== Specification ==== | ==== Specification ==== |
| |
|Hor Bed Temperature|100°C| | |Hor Bed Temperature|100°C| |
| |
===== Guides ===== | |
| |
==== Troubleshooting ==== | |
[[https://www.simplify3d.com/support/print-quality-troubleshooting/|Print Quality Troubleshooting Guide on simplify3d.com]]\\ | |
| |
{{ :reprap:anet:print-quality-troubleshooting-guide-anet.pdf |}}\\ | |
source:[[http://www.anet3d.com/uploads/soft/160525/Print-Quality-Troubleshooting-Guide-Anet.pdf|anet3d.com]] | |
==== Calibration ==== | ==== Calibration ==== |
[[http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide|Triffid Hunter's Calibration Guide on reprap.org]] | [[http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide|Triffid Hunter's Calibration Guide on reprap.org]] |
[[reprap:electronics:heatbed_mosfet|Howto: Connect your Heatbed to a Relay]] | [[reprap:electronics:heatbed_mosfet|Howto: Connect your Heatbed to a Relay]] |
| |
| ==== Printable Things ==== |
| === Fan related === |
| * [[http://www.thingiverse.com/thing:1822438|Anet A6 Duct + V2 - Anet A6 ventillation by xkeliff]] |
| |
| |
| === Add-Ons === |
| * [[http://www.thingiverse.com/thing:1867669|Anet A6 Dust Cap for Z-Rod (Move freely / No Dust) ]] |