Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:05] – [Attaching the BLTouch] vidschofelix | firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:06] (current) – [Why?] vidschofelix | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== HowTo Run BLTouch connected to RPi microcontroller ====== | ====== HowTo Run BLTouch connected to RPi microcontroller ====== | ||
| ==== Why? ==== | ==== Why? ==== | ||
| - | * some printer board dont support the control signal for the bltouch, or need to remove some components. In this case you have to fiddle a little | + | * some printer board dont support the control signal for the bltouch, or need to remove some components. In this case you have to fiddle a little but it's possible, so why not? |
| ==== Needed ==== | ==== Needed ==== | ||