Wanhao's Product Page
(May contain errors and oversimplifications, should not be thought of as authoritative, here for reference only)
Printing Technology: Fused Filament Fabrication (FFF)/(FDM)
Build Volume: 200mm x 200mm x ~180mm (tall)
Layer Resolution: from Low of 200microns to Ultra 20 microns
Positional Precision: X 12.5 microns, Y 12.5 microns, Z 5 microns
Printing Material: PLA, ABS, PVA, PEVA, HIPS
Filament Diameter: 1.75mm
Nozzle Diameter: 0.4mm
Print Speed: 30mm - 150mm/s
Travel Speed: 30mm - 150mm/s
Extruder Temperature Range: 180degC - 260degC
Heated Build Plate Temp Range: 50degC - 100degC
Physical Dimensions:
Operating Conditions:
Ambient Operating Temperature: 15degC - 32degC
Storage Temperature: 0degC - 32degC
Average Noise Level: 49dB
Electrical Specifications:
AC Outlet Input: 100-240V, 50-60Hz
Power Consumption: ~4 Amps, 221 Watt Max
Wanhao's Duplicator 6 User Manual rev A
Wanhao's Duplicator 6 eBrochure
[Copied from Wanhao Specs page, changes/corrections in BOLD]
Printing Technology: Fused Filament Fabrication (FFF)/(FDM)
Build Volume: 200mm x 200mm x ~180mm (tall)
Layer Resolution: from Low of 200microns to Ultra 20 microns
Positional Precision: X 12.5 microns, Y 12.5 microns, Z 5 microns
Printing Material: PLA, ABS, PVA, PEVA, HIPS (Additional materials possible after hot end upgrades)
Filament Diameter: 1.75mm
Nozzle Diameter: 0.4mm (possible to change to 0.2mm - 0.6mm with replacement parts)
Print Speed: 30mm - 150mm/s
Travel Speed: 30mm - 150mm/s
Extruder Temperature Range: 180degC - 200degC (Above 200degC, the PTFE tube in the heat block will begin breaking down, causing clogs and releasing toxic? gases)
Heated Build Plate Temp Range: 50degC - 120degC
Physical Dimensions:
Operating Conditions:
Ambient Operating Temperature: 15degC - 32degC
Storage Temperature: 0degC - 32degC
Average Noise Level: 49dB (Much quieter after installing motor dampers)
Electrical Specifications:
AC Outlet Input: 100-240V, 50-60Hz
Power Consumption: ~4 Amps, ~300 Watt Max (when both heaters are active)