These are the most asked questions.
Calibration is normally not needed as this is carried out by the manufacturer and stored in the factory installed firmware. Information on printer calibration:
Sometimes the center of the bed is not the actual center. When printing large prints, the skirt, brim or the object itself is printed outside the heated bed. For bed center offset calibration please read:
| Part | Description | Where to buy? |
|---|---|---|
| Belts | GT2 6mm Open Timing Belts | Ebay |
| Heater Block | E3D V6 | Ebay |
| Motherboard | RAMPS 1.4 | Ebay |
| PSU | 12V, 30A, 360W | Ebay |
| Throat | E3D V6 Throat | Ebay |
| Nozzle | E3D V6 M6-Thread | Ebay |
| Extruder | 1.75mm Titan Extruder kit | Ebay |
| Extruder Motor | 17-Stepper Motor | Ebay |
| Linear Bearings | ||
| Linear Bearings Upgrade | ||
| Heatbed Upgrade | ||
| Thermistor for Heatbed | ||